Water Strider Rafts Battery Kit Info

Water Strider Rafts
Online Store

One Man Raft Kickboat: An Inflatable Raft Better Than A Drift Boat

The best kickboat raft on any river or lake for Total Access!

BATTERY KIT
BK Ni Mh BK PB-Gel

The BK-battery kit, in the Ni-Mh (high power) and Pb-gel versions, is a specific accessory for Bravo BTP Manometer, BTP Digital and BP inflators.

Technical characteristics of the “BK Ni-Mh” (high power) battery
-Nominal voltage 12V DC
-Battery capacity 7A/h
-Endurance fully charged can carry out approximately 40 minutes of inflation/deflation at medium pressure.
-Recharging time approximately 10 hours
-Life cycles approximately 800

WARNING:
-Before using for the first time or after a long period of inactivity, ensure the battery is fully charged.

-Using a charger other than that supplied in the kit may damage the battery.

Technical characteristics of the “BK Pb-gel” battery
-Nominal voltage 12V DC
-Battery capacity 7A/h
-Endurance fully charged can carry out approximately 20 minutes of inflation/deflation at medium pressure.
-Recharging time approximately 8 hours
-Life cycles approximately 400

WARNING:
-Before using for the first time or after a long period of inactivity, ensure the battery is fully charged.

-Using a charger other than that supplied in the kit may damage the battery.

If left uncharged, even for a short time, Pb-gel batteries risk swift and permanent damage. After use, recharge the battery as soon as possible!
The guarantee does not cover premature damage made to the battery caused by a failure to recharge.

Technical characteristics of the “BK battery charger”
This charger has been developed to charge BK Ni-Mh (high power) and Pb-gel type batteries. It can be used with a supply voltage from 100 to 240 V AC and is supplied with two power cables, in USA and Europe versions.
-Supply voltage 100-240 V AC
-Maximum absorption 0.6 A
-Maximum recharging voltage 14.8 V DC
-Maximum recharging current 1000 mA

WARNING: - Do not use the battery charger in damp conditions.

- Do not use the battery charger with other batteries or for uses other than that for which it is intended.

Connecting the battery to the BTP/BP inflator:
- Open the inflator bag’s central hinge, disconnect and extract the charging clip cable supplied as standard to the inflator.
- Put the battery in its pocket and connect the power cable to the inflator.

Charging the battery:
-Insert the charger’s charging plug to the battery.
-Choose the appropriate supply cable (USA or Europe); plug it into the seat on the battery charger and in the mains plug (from 100 to 240 AC).
-The red LED light comes on during charging; the battery is charged when the green LED light comes on.
-As soon as the battery is charged, disconnect the battery charger from the mains and from the battery immediately in order to avoid the battery running down completely.

The battery has a three-month guarantee.

Made in China by Ningbo Bravo co.ltd
Imported by Scoprega S.p.A.

Dealers, Lodges, Guides contact Dave for Water Strider's Wholesalers Program.

dave@waterstrider.com

or call 406 375-0251

The Water Strider web is:

Water Strider | 263 Three Pond Drive | Hamilton, Montana 59840
phone and fax 406.375.0251 | contact Water Strider